top
Slitting machine operating procedures
Slitting machine operating procedures

 

Slitting machine operating procedures

1. The operator should be trained before seizing the post, and must be aware of the employment of various slitting machines! instrumentation performance and customary maintenance methods. Personnel who don't seem to be during this sort of work shall not operate at will;

2. Do an honest job of labor protection before beginning the machine, prepare some auxiliary tools and materials for operation (knife adjustment tools, cartons requested by the operation, paper tubes, paper cutters, tapes, etc.) and place them during a appropriate position on the machine;

3. make sure that the instrumentation is during a safe state,
Check whether or not the circuit is lack of part and therefore the air circuit is unblocked, and check out to run the machine to ascertain whether the electrical, pneumatic, and mechanical instrumentation are operational normally. whether or not the protecting facilities of the machinery are complete. throughout operation, forestall crushing, scratching or transfer into rotating gears, chains, rollers, etc.;

4. Knife alterment: adjust the precise tool distance in keeping with the work request and listen to the direction of the knife edge. If necessary, take away the bedknife and re-arrange the knife. If the knife is broken or not sharp, it should be repaired and replaced;

5. Investigate the association between the static elimination instrumentation and therefore the machine ground to make sure that the electricity of the info is eliminated throughout operation. Lay paper beneath the machine to avoid mud absorption;

6. listen to safety once loading materials. Push the fabric to an acceptable position to prevent the inflation, and pay attention to the direction of rotation of the material to not be reversed;

7. Paper threading and edge alignment: thread the info from moving to rewinding in keeping with the direction set by the equipment, and alter the correction position to prevent the alignment. once trimming the stings, make sure that there's glue on each side of the finished product, and listen to correction when feeding. stroke. make certain to travel to the center of the deviation correction stroke, pay attention to the deviation correction side throughout operation, when the stroke is exceeded, it'll seem that the edge can not be cut, and forthwith take care of it;

8. place the paper tube requested by the work on the reel and align the data. If you would like to stick double-sided tape, you need to paste the double-sided tape, alter the suitable winding tension and moving tension, and perform trimming and winding;

9. throughout the winding process, the standard of the merchandise should be strictly inspected. Inferior merchandise or waste products and alternative taken product or edges mustn't be rolled into the product, and therefore the variety of meters ought to be strictly controlled;

10. once stopping unloading, please hold the fabric with one hand and pull the merchandise out of the expansive shaft. the fabric for the photo-painted surface should wear gloves, and no fingerprints ought to be left on the product;

11. in keeping with the assembly requirements, complete the corresponding and complete packaging, as well as labeling and packaging paper or film, sealing, batch numbering, etc.;

12. once stopping the machine, put off the facility and air source, and perform the mandatory improvement and maintenance of the machine. strive to not scrape the excessive roller with a knife, and wipe the glue on the instrumentation with a solvent;

13. If you encounter issues throughout the operation, in principle, stop the machine for processing. If you can't stop the machine for processing, you need to bog down and take care of it carefully.

Leave a Reply

Your email address will not be published. Required fields are marked *

Sunny Machinery Factory
already 1 902 messages

  • sunnymachinery 10:12 AM, Today
    Hello, dear sir/madam, welcome to our website! I’m sunnymachinery,how should I address you?